Semi-automatic terminal machine is a very common wire harness processing equipment in the market, which is very popular in the market at present because of its strong applicability and low price. For buyers, they don't know much about the relevant information of semi-automatic terminal machines, so many people extend the operation method of fully automatic terminal machines to semi-automatic terminal machines, but these two types of machines are very different, and the operation methods are different because of their different working methods. 1. Before turning on the power supply, try the foot switch first, and make sure it works normally. 2. When the machine is turned on, if the sound is abnormal, it is necessary to inform the equipment technician for inspection in time. 3. When adjusting the die and tool holder, the power supply must be cut off for debugging. Adjust the press height of the machine, and manually press the rotary direction to test the press. 4. When turning on the equipment, first enter the main screen, and then debug the related processing parameters. 5, the staff can't move, dismantle the equipment, testing instruments, adjust the parameters set by the equipment without authorization, and contact the equipment technician if necessary. 6. During operation, pay attention to placing the wire in the middle of the clamping jaw to prevent the wire from being pinched. 7. If a new type of wire rod needs to be processed, the equipment technician should first adjust the equipment parameters. When adjusting, the machine should be stopped before adjusting the parameters, and the adjusted wire rod can be handed over to the processing operation. 8, in the process of use, if abnormal situation or abnormal test results are found, the use should be stopped immediately, and the equipment technician can put it into use after debugging, repairing and calibrating. 9. When the deviation of inspection equipment is confirmed, the products that have been inspected in the past should be re-evaluated and re-inspected if necessary. If the products are found to be unqualified due to inspection equipment problems, the processing parameters of the machine should be re-adjusted first, and then re-processed. 10. When the terminal hits the end, keep your hands away from the upper and lower riveting knives to avoid injury. The above is the safety operation rules of semi-automatic terminal machine. If you want to achieve safe production, efficient production and high-quality finished products, you can't do without a good machine operator, so a good and safe operation method is the foundation. I hope the above contents can help you!
Previous：Already the first article
Next：Safety operation procedures of automatic wire stripping machine
